BLee good luck with the projects, and don't get discouraged if a part does not work out the first, 2 or 3 times just keep at it. God knows how make parts I f-ed up before they came out right. I also suggest you try and get commercial sand for the molds it much better & easier than making your own! But with that said making your own green sand is sooooo much cheaper :) - Brian
--- In gingery_machines@yahoogroups.com, "cylon_blee" <cylon_blee@...> wrote:
>
> Hello all.
> I've been lurking here for a few months now as I've been gathering up materials to start working through Mr. Gingery's "Metal Shop from Scrap" series. I wanted to stop by and say "Thanks" for all the good information and inspiration I've found here thus far.
>
> Also, I finally have progress to report: over the past weekend I finished the charcoal furnace. I built it pretty close to standard; the only "improvement" I made was to locate the tuyere in the bottom center of the furnace, rather than in the side. My limited research made me think that might work a little better, but who knows. The lining cured up fine with no cracks.
>
> I've got to say that when I turned on the air blast for the first time and saw a 2' jet of flame shoot out the vent, I was pretty stoked.
>
> Thanks again guys. I'm sure I'll have questions once I start molding and melting.
>
> Best,
> BLee
>
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map
No comments:
Post a Comment