Re: [gingery_machines] new article available: A Variable Frequency Drive plus Three Phase Motor on a RF30 Mill/Drill

 

On 6/22/2011 10:24 AM, RG Sparber wrote:
>
> Over the last few days I installed a Variable Frequency Drive plus three
> phase motor on my RF30 Mill/Drill. Here are a few pictures of the effort.
>
> http://rick.sparber.org/VFD.pdf
>
> Rick
>
Thanks for sharing. I was a little surprised at the total cost.

On a side note, there is a RF-30 on the local Craig's list today. $950.00
http://spacecoast.craigslist.org/tls/2454562280.html

--

Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA

There are two kinds of posts on newsgroups.
1. This is what I have done...
2. This is what I think...
Be aware of the difference!

http://www.ourcadguy.com/

http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/

Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/

[Non-text portions of this message have been removed]

__._,_.___

Reply to sender | Reply to group | Reply via web post | Start a New Topic

Messages in this topic (2)

Recent Activity:

• New Members 3
• New Photos 1

Visit Your Group

<*> Member map - Who and where we are.  Please add yourself so members can find each other.
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map

Switch to: Text-Only, Daily Digest • Unsubscribe • Terms of Use

.

__,_._,___