Ron,
I agree that it was a bit expensive but motor and drive were new. They go
for a lot less on the used market.
Rick
-----Original Message-----
From: gingery_machines@yahoogroups.com
[mailto:gingery_machines@yahoogroups.com] On Behalf Of Ron Thompson
Sent: Wednesday, June 22, 2011 8:14 AM
To: gingery_machines@yahoogroups.com
Subject: Re: [gingery_machines] new article available: A Variable Frequency
Drive plus Three Phase Motor on a RF30 Mill/Drill
On 6/22/2011 10:24 AM, RG Sparber wrote:
>
> Over the last few days I installed a Variable Frequency Drive plus three
> phase motor on my RF30 Mill/Drill. Here are a few pictures of the effort.
>
> http://rick.sparber.org/VFD.pdf
>
> Rick
>
Thanks for sharing. I was a little surprised at the total cost.
On a side note, there is a RF-30 on the local Craig's list today. $950.00
http://spacecoast.craigslist.org/tls/2454562280.html
--
Ron Thompson
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map
No comments:
Post a Comment