Dave,
Point well taken. I will add it to the article and publish it in a few minutes.
Thanks,
Rick
-----Original Message-----
From: gingery_machines@yahoogroups.com [mailto:gingery_machines@yahoogroups.com] On Behalf Of David Patterson
Sent: Thursday, June 02, 2011 8:16 PM
To: gingery_machines@yahoogroups.com
Subject: RE: [gingery_machines] new article available: Drill, Tap, and Counterbore
Rick every drill press has a stop. It can be anything from a piece of wood with a hole drilled in it and the proper length, to a piece clamped to stop the handles from rotating too far. I do assume that beginners would have at figured out how to stop a drill from going deeper than it should.
Dave Patterson
odd_kins@yahoo.com
http://home.comcast.net/~oddkins/foundry_home.html
--- On Thu, 6/2/11, RG Sparber <rgsparber@aol.com> wrote:
From: RG Sparber <rgsparber@aol.com>
Subject: RE: [gingery_machines] new article available: Drill, Tap, and Counterbore
To: gingery_machines@yahoogroups.com
Date: Thursday, June 2, 2011, 7:42 PM
Dave,
You are assuming I have a depth stop on my drill press. Without a stop, I felt that removing the bottom part was the best way to insure it didn't get hit with the clearance drill bit.
I usually use my drill press to just knock holes in stuff. Normally I would do this drill, tap, counterbore operation in my mill/drill which has a DRO.
Rick
-----Original Message-----
From: gingery_machines@yahoogroups.com [mailto:gingery_machines@yahoogroups.com] On Behalf Of David Patterson
Sent: Wednesday, June 01, 2011 4:02 PM
To: gingery_machines@yahoogroups.com
Subject: Re: [gingery_machines] new article available: Drill, Tap, and Counterbore
Rick I do the same in one setup, with the top and bottom pieces clamped in the mill. one hole at a time, but no disassembley of the pieces until complete.
Drill the tap drill to the proper depth or through both pieces, as required. Use a stop to set the depth.
Remove the tap drill, install the body drill, set the stop or use a dial indicator for the depth of the body drill. This will countersink for the threads if done right.
remove the body drill and counter bore or counter sink as required. An off center counter sink will move a part more than an offset counter bore.
Remove the clamps and tap the bottom piece without clamping it. Use the drill press or mill, manually(turn by hand), to start the tap. this keeps it inline with the axis of the hole. The tap will self center on the hole when started this way. All holes are finished, except for the tapping operation without breaking down a setup. if done right the only debur left is to the top of the counterbore or countersink and if you drilled through both pieces, the bottom of the tapped hole. This can be done with either a mill or drillpress.
Dave Patterson
[Non-text portions of this message have been removed]
------------------------------------
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map
No comments:
Post a Comment