confed2001
No, if you made your link 2.25" long the only thing that would is not pull the .125" forward and the same in the back it would travel .125 longer. You need to turn the shaft until it locks up. Then inspect the inside of your shaper and find what the hold up is. You must find the two points that meet and bind up. If you added small amounts it should not have that much bearing. If you take your links loose will the ram slide both directions without stopping?
Hope that helped
Nelson Collar
--- On Wed, 6/22/11, confed2001 <confed2001@yahoo.com> wrote:
From: confed2001 <confed2001@yahoo.com>
Subject: [gingery_machines] Re: Shaper Question (Help)
To: gingery_machines@yahoogroups.com
Date: Wednesday, June 22, 2011, 2:24 AM
Nelson,
Thanks for the input. So you are saying that the 2 links joining the Ram Clamp & Yoke are to long? (I did make them 1/8" to long).
Thanks,
Brian
--- In gingery_machines@yahoogroups.com, Nelson Collar <nel2lar@...> wrote:
>
> confed2001
> Yes that could be your problem. Turn your crank to the point it locks up and get a flash light and look at that point that is too long. If it is the problem just cut 1/4" off and try again. Good luck with the build, you have come tooo far to stop now.
> Nelson Collar
>
> --- On Wed, 6/22/11, confed2001 <confed2001@...> wrote:
>
>
> From: confed2001 <confed2001@...>
> Subject: [gingery_machines] Shaper Question (Help)
> To: gingery_machines@yahoogroups.com
> Date: Wednesday, June 22, 2011, 1:05 AM
>
>
> Â
>
>
>
> I have the Shaper & Counter Shaft mounted to a bench. I am just about ready to plan the work table, but when I set the Ram for its longest stroke I get about a 3/4 turn and it jams just as soon as it hits the forward stroke. The jam is not cause by the slide block in the Yoke, because when I take the ram/clamp off it moves just fine. I am thinking that it is jamming somewhere between the Ram Clamp & the Yoke. The plans call for the 2 Links that join the Yoke to the Ram Clamp (pg. 65) to be 2-1/8" long. I made mine 2-1/4" long (did not realize I did this until I took it apart). So are these links to long, or should I make them a little longer? I have rounded the ends of both the Yoke & Ram Clamp as much as I dare thinking that they may be hitting, but that did not help. So any ideas PLEASE!!!!
>
> Brian
>
>
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
[Non-text portions of this message have been removed]
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map
No comments:
Post a Comment