Pierre,
Along these same lines, it would be easy to make a set of Go-No go gages.
Take some bar stock, drill and tap two holes. Drill flanking holes that are
perpendicular to the tapped holes major axis. Modify these holes so they
work like a clamp. Then you can set the space between the half nuts.
Rick
-----Original Message-----
From: gingery_machines@yahoogroups.com
[mailto:gingery_machines@yahoogroups.com] On Behalf Of Pierre Coueffin
Sent: Thursday, August 25, 2011 9:52 AM
To: gingery_machines@yahoogroups.com
Subject: Re: [gingery_machines] Re: new article: A Possible Means of
Measuring a Thread's Pitch Diameter
In the kerf where you sawed the nut in half. If you tilt the two
halves to touch on one side, they should form a gap on the other side
that is consistent from bolt to bolt, assuming that the bolts are all
the same size. I think that you could estimate the difference between
PD of two bolts using the difference in the gap and a bit of
trigonometry.
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map
No comments:
Post a Comment