Rick
I must say you hit a home run on that article. One of the best ideas and execusion I have
seen. Nice job, but you usually do.
Nelson Collar
--- On Sat, 9/3/11, RG Sparber <rgsparber@aol.com> wrote:
From: RG Sparber <rgsparber@aol.com>
Subject: [gingery_machines] new article: An Improved Tool Support for a Harbor FreightR Tool Grinder
To: valleymetal@yahoogroups.com, gingery_machines@yahoogroups.com, mill_drill@yahoogroups.com, atlas_craftsman@yahoogroups.com
Date: Saturday, September 3, 2011, 11:01 PM
As with most Harbor FreightR products, there is room for improvement. The
Harbor FreightR Tool Grinder is no exception.
It has a tool support that, to put it politely, limits the potential value
of the machine. This article presents a replacement tool support that
corrects two major problems: limited angular range and poor slider fit.
This article was written with the experienced hobbyist in mind. A person new
to our hobby might have trouble following the steps. However, if you want to
give it a try, feel free to contact me for additional help.
If you are interested, please see
http://rick.sparber.org/ngc.pdf
Your comments and questions are welcome. All of us are smarter than any one
of us.
Rick
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map
No comments:
Post a Comment