RE: [gingery_machines] new article: Making it Dead Flat and Square

 

Hi Rick
The numbers amazed me as to how accurate it was.
First I check the micrometers with a gage block for a standard.
   they were checked about two inchs apart,and most of it
was less than 0.0005 veriance in them.
 
 Keith

Deep Run Portage
Back Shop
" The Lizard Works"

--- On Sun, 1/2/11, Rick Sparber <rgsparber@aol.com> wrote:

From: Rick Sparber <rgsparber@aol.com>
Subject: RE: [gingery_machines] new article: Making it Dead Flat and Square
To: gingery_machines@yahoogroups.com
Date: Sunday, January 2, 2011, 8:19 PM

 

Keith,

Did you mean to say 0.0005" and not 0.005"? Half a thou is very impressive unless it is ground stock.

Rick

-----Original Message-----
From: gingery_machines@yahoogroups.com [mailto:gingery_machines@yahoogroups.com] On Behalf Of keith gutshall
Sent: Sunday, January 02, 2011 6:40 PM
To: gingery_machines@yahoogroups.com
Subject: RE: [gingery_machines] new article: Making it Dead Flat and Square

Hello Nelson
I got some CRS fom Speedy Metals ,and checked it with a mike . The most of it
was about only a 0.0005 out of size.
That did not look to bad to me.

Keith

[Non-text portions of this message have been removed]

__._,_.___

Reply to sender | Reply to group | Reply via web post | Start a New Topic

Messages in this topic (49)

Recent Activity:

• New Members 11
• New Photos 16

Visit Your Group

<*> Member map - Who and where we are.  Please add yourself so members can find each other.
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map

Switch to: Text-Only, Daily Digest • Unsubscribe • Terms of Use

.

__,_._,___