RE: [gingery_machines] new article: A 45 degree Jaw Set for a Horizontal/Vertical Bandsaw

 

Nelson,

Now I understand! Time to go back into the shop and give it a try.

Thanks,

Rick

-----Original Message-----
From: gingery_machines@yahoogroups.com [mailto:gingery_machines@yahoogroups.com] On Behalf Of Nelson Collar
Sent: Saturday, May 07, 2011 3:18 PM
To: gingery_machines@yahoogroups.com
Subject: Re: [gingery_machines] new article: A 45 degree Jaw Set for a Horizontal/Vertical Bandsaw

Rick
No then you tighten up the clamp, if it was metal, you would need more pressure on the clamp. With the part to be cut being above the clamp, the bottom of clamp would close more than the top and possibly allow the piece to slip out. If you had the same cut out on top and bottom, using a scrap piece on the bottom the clamp would close even top and bottom, less tendency to slip upward.

__._,_.___

Reply to sender | Reply to group | Reply via web post | Start a New Topic

Messages in this topic (20)

Recent Activity:

• New Members 8

Visit Your Group

<*> Member map - Who and where we are.  Please add yourself so members can find each other.
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map

Switch to: Text-Only, Daily Digest • Unsubscribe • Terms of Use

.

__,_._,___