RE: [gingery_machines] new article: 45 degree Jaw Set for a Horizontal/Vertical Bandsaw

Saturday, May 7, 2011

Malcolm,

I have sent you a few pictures off line so we can straighten out this confusion.

Rick

-----Original Message-----
From: gingery_machines@yahoogroups.com [mailto:gingery_machines@yahoogroups.com] On Behalf Of Malcolm Parker-Lisberg
Sent: Saturday, May 07, 2011 6:13 PM
To: gingery_machines@yahoogroups.com
Subject: Re: [gingery_machines] new article: 45 degree Jaw Set for a Horizontal/Vertical Bandsaw

Rick

Sorry but what you have in the article is not what I was suggesting.
My idea was indeed to allow the moving jaw to rotate to 45 deg, but only use one of aluminium angle pieces, the one with the notches. Turn it over so the notches in the angle are against the saw table holding the workpiece from above, one leg of the aluminium angle still sticking out perpendicular to the fixed jaw. The moving jaw against the workpiece clamping it into the cut outs. A clamp would still needed to hold the alumunium angle against the fixed jaw.

Malcolm

__._,_.___

Reply to sender | Reply to group | Reply via web post | Start a New Topic

Messages in this topic (22)

Recent Activity:

New Members 8

Visit Your Group

<*> Member map - Who and where we are. Please add yourself so members can find each other.
http://groups.yahoo.com/group/gingery_machines/app/peoplemap/view/map

MARKETPLACE

Stay on top of your group activity without leaving the page you're on - Get the Yahoo! Toolbar now.

Find useful articles and helpful tips on living with Fibromyalgia. Visit the Fibromyalgia Zone today!